menu x
menu x

News

FREE COOLUBE. This offer ends 30th June so hurry now, only 2 weeks left

FREE Bottle of Coolube® When you buy a Coolubricator, saw system or any other piece of Unist Hardware over and…
CONTINUE READING

Saw conversion using our new nozzle configuration from Coolant to Near Dry, no mess, dry chips.

https://www.youtube.com/watch?v=w5Rs5-2ZbsU Check out our new nozzle manual. Previously running on a coolant mixture, this machine created an absolute mess for…
CONTINUE READING

Drilling 25 mm diameter holes through steel pipe.

https://www.youtube.com/watch?v=sAsI5gXo2j0 Watch how we drill 25 mm diameter holes through toughened steel tube with a wall thickness of 5 mm,…
CONTINUE READING

Unist’s Genuine Life Time Warranty.

Unist only uses the finest material in our pumps Stainless Steel,Brass, Aircraft grade aluminium and Viton for the seals which…
CONTINUE READING

How to clean up Coolube from parts.

Cleaning residual Coolube from parts In most cases there should be little if any Coolube left on the part.  If…
CONTINUE READING

New: Stainless Steel Nozzle Tip. Plastic nozzle tips being chewed up? It might be time for something tougher!

Plastic nozzle tips being chewed up? It might be time for something tougher! Available now, our stainless steel nozzle tip…
CONTINUE READING

Dry Chips using Coolube (MQL) Collect your chips in a cardboard container: A Clean, Safe and cost effective solution to toxic waste coolant.

https://www.youtube.com/watch?v=8GjjKbN33-M Coolube® has distinct advantages over traditional flood coolant. This video discusses the benefits of dry chips using Coolube®  
CONTINUE READING

Remotely adjust your Low Volume (LV) Spray Nozzles! Adjust the fluid and air at the remote adjustment solenoid valve bank connected to our SPR-2000™ programmable fluid controller.  

https://www.youtube.com/watch?v=I4w0nlrVU94 Adjust the fluid and air at the remote adjustment solenoid valve bank connected to our SPR-2000™ programmable fluid controller.…
CONTINUE READING

Changing from Alucobond/Composite panel to Solid Aluminium Sheet

Do you find yourself having to Route 3mm solid Aluminium sheet in preference to Alucobond/Composite panel? If you are experiencing any of the following you need to talk to our John Barker (Managing Director) of Unist Australia.

  • Ragged cutting
  • Burning out cutters
  • Breaking router bits
  • Terrible surface finish
  • Just the inability to get the job done

We understand your problem, you need to lubricate the routing cutter with our 3 nozzle Coolubricator.

For help on this matter call John Barker on 02 8850 2022 or email [email protected].

Watch a Routing video: https://unist.com.au/routing

The facade industry is moving in part from ACM to Solid Aluminium panels. HVG/Alucobond Architectural are introducing MondoClad, a Pre-finished 3 mm aluminium panel.For more information go to:

https://hvgfacades.com.au/